Samsung HPN5039 Owners Instructions - Page 7

Remote Control Buttons Remote Control Œ POWER button Turns the PDP on and off. ´ ASPECT button Press to change the screen size. ˇ Number buttons ¨ +100 button Press to select channels over 100. For example, to select channel 121, press "+100", then press "2" and "1." ˆ MUTE button Press to mute the PDP sound. Ø VOL (Volume) buttons Use it to adjust volume. ∏ SLEEP button Press to select a preset time interval for automatic shutoff. " MENU button Displays the main on-screen menu. ' ENTER button Confirms a selection. ˝ PIP button Activates picture in picture. Ô STILL button Press to pause the current screen.  LED Display When you press a button, ' ' appears along with selected mode (TV, CATV, DVD or STB) and remaining batteries on LED. Ò P.MODE button Adjust the PDP picture by selecting one of the preset factory settings (or select your personal, customized picture settings.) Ú MODE button Selects a target device to be controlled by the Samsung remote control (ie., VCR, Cable, DVD players or STB). If you change modes, the new mode is momentarily displayed on LED. Æ PRE-CH button Tunes to the previous channel. ı TV/VIDEO button Press to display all of the available video sources (ie., Video, S-Video, Component1, Component2, PC, DVI). ˜ CH (Channel) buttons Use it to switch channels. ¯ INFO button Press to display information on the PDP screen. ˘ EXIT button Press to exit the menu. ¿ Up/Down Left/Right buttons 12 Control the cursor in the menu. ¸ SURROUND button Press the hear the Dolby surround effect. ˛ MTS button Press to choose stereo, mono or Separate Audio Program (SAP broadcast). ◊ AUTO PROG. button The TV automatically cycles through all of the available channels and stores them in memory. ± ADD/DEL button Press to add or delete channels in the TV's memory. ≠ DNIe button Activates DNIe (Digital Natural Image engine). - CAPTION button Controls the caption decoder. - SET button Used during set up of this Samsung remote control, so that it will work compatibly with other devices (VCR, cable box, DVD) ÷ PIP control buttons SWAP : Exchanges the video signal that is currently displayed on the main screen with the signal in the PIP window. SIZE : Press to make the PIP window Large, Small or Double. CHv,w : Displays the available channels in sequence. (These buttons change channels in the PIP window only). ® VCR, DVD control buttons Controls VCR tape or DVD disc functions: Stop, Rewind, Play/Pause, Fast Forward. ∑ RESET button If your remote control is not functioning properly, take out the batteries and press the reset button for about 2~3 seconds. Re-insert the batteries and try using the remote control again. Installing the Batteries in Your Remote Control 1 Slide the back cover to open the battery compartment of the remote control. 2 Install two AAA size batteries. Make sure to match the "+" and "-" ends of the batteries with the diagram inside the compartment. 3Slide the cover back into place. Remote Control Operation Range. You can use your remote control within a distance of 23 feet and an angle of 30 degrees from the left and right sides of the PDP's remote control receiver. 13