Samsung SCX 6555N User Manual (ENGLISH) - Page 25
Getting Started, Setting up the hardware, Setting up the network, Supported operating systems
UPC - 635753610314
View all Samsung SCX 6555N manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 25 highlights
getting started This chapter gives you step-by-step instructions for setting up the machine. This chapter includes: • Setting up the hardware • Setting up the network • System requirements • Installing the software • Machine's basic settings • Understanding the keyboard SETTING UP THE HARDWARE This section shows the steps to set up the hardware which is explained in the Quick Install Guide. Make sure you read Quick Install Guide and complete following steps. 1. Select a stable location. Select a level, stable place with adequate space for air circulation. Allow extra space to open covers and trays. The area should be well-ventilated and away from direct sunlight or sources of heat, cold, and humidity. Do not set the machine close to the edge of your desk or table. 4. Install both the print cartridge and imaging unit. 5. Load paper. (See "Loading paper" on page 36.) 6. Make sure that all the cables are connected to the machine. 7. Turn the machine on. • When you move the machine, do not tilt or turn it upside down. Otherwise, the inside of the machine may be contaminated by toner, which can cause damage to the machine or bad printing quality. • If you are moving the machine or if machine is not in use for a long time, turn on the power and wait until it goes in to the ready mode. Then close the scan lid and turn the power off. And open the scan lid and lock the scanner lock. • This equipment will be inoperable when mains power fails. Printing is suitable for altitudes under 1,000 m (3,281 ft). Refer to the altitude setting to optimize your printing. See page 27 for more information. Place the machine on a flat, stable surface so that there is no incline greater than 5 mm (0.02 inch). Otherwise, printing quality may be affected. 2. Unpack the machine and check all the enclosed items. 3. Remove the tape holding the machine tightly. SETTING UP THE NETWORK You need to set up the network protocols on the machine to use it as your network printer. You can set up the basic network settings with the machine's touch screen. If you want to use the USB cable, connect the cable between a computer and you machine. Then, refer to Software section. Supported operating systems The following table shows the network environments supported by the machine: ITEM REQUIREMENTS Network interface Ethernet 10/100/1000 Base-TX Network operating system • Novell NetWare 5.x, 6.x • Windows 2000/XP/2003/2008//7/Server 2008 R2 • Various Linux OS • Mac OS 10.3 ~ 10.6 Network protocols • TCP/IP • EtherTalk Dynamic addressing server DHCP, BOOTP If you are in a non-static IP address environment and need to set up a DHCP network protocol, go to http://developer.apple.com/networking/ bonjour/download/, select the Bonjour program that is appropriate for your computer operating system and install the program. This program will allow you to set network parameters automatically. Follow the instructions in the installation window. This program does not support Linux. Getting Started_ 24