Sanyo PDG-DWT50L Owners Manual - Page 124

8. Specifications PC Control Codes and Cable Connections This projector provides a function to control and monitor the projector's operations by using the RS-232C serial port. 1. Connect a RS-232C serial cross cable to SERIAL PORT IN on the projector and serial port on the PC. 2. Launch a communication software provided with PC and setup the communication condition as follows: Baud rate : 38400 bps Parity check : none Stop bit : 1 Flow control : none Data bit : 8 3. Type the command for controlling the projector and then enter the "Enter" key. Example When you want to change the input to Computer 2, Type "C" "0" "6" "Enter." The below table shows the typical command lists for controlling the projector. Please consult your local dealer for further information of another commands. Functional Execution Command Table COMMAND C00 C01 C05 C06 C07 C08 C09 C0A C0B C0C C0D C0E C0F C10 C1C C1D C33 C34 FUNCTION Turn the projector ON Turn the projector OFF (immediately OFF) Selects Computer 1 Selects Computer 2 Selects Computer 3 Selects Component Volume UP Volume DOWN Audio mute ON Audio mute OFF Video mute ON Video mute OFF Aspect 4:3 Aspect 16:9 Menu ON Menu OFF Selects Video Selects S-video COMMAND C3A C3B FUNCTION Pointer RIGHT Pointer LEFT C3C Pointer UP C3D Pointer DOWN C3F Enter C46 Zoom DOWN C47 Zoom UP C4A Focus DOWN C4B Focus UP C5D Lens shift UP C5E Lens shift DOWN C5F Lens shift LEFT C60 Lens shift RIGHT C89 Auto PC Adj. C8E Keystone UP C8F Keystone DOWN C90 Keystone RIGHT C91 Keystone LEFT 115