Sanyo PDG-DWT50L Owners Manual - Page 5
Important Information, IMPORTANT, Clean the Filter Regularly - lamps
UPC - 086483067563
View all Sanyo PDG-DWT50L manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 5 highlights
Important Information Air Circulation Openings in the cabinet are provided for ventilation. To ensure reliable operation of the product and to protect it from overheating, these openings must not be blocked or covered. CAUTION Hot air is from the exhaust vent. When using or installing the projector, the following precautions should be taken. − Do not put any flammable objects or spray cans near the projector, hot air is exhausted from the air vents. − Keep the exhaust vent at least 3 feet (1 m) away from any objects. − Do not touch peripheral parts in the exhaust vents, especially screws and metallic parts. These areas will become hot while the projector is used. − Do not put anything on the cabinet. Objects put on the cabinet will not only get damaged but may also cause a fire hazard. Cooling fans are provided to cool down the projector. The fans' running speed is changed according to the temperature inside the projector. IMPORTANT! Clean the Filter Regularly!! The projector uses a lamp which generates significant heat. The cooling fans and air vents are provided to dissipate the heat by drawing air into the housing and the filter is located in the intake vents to prevent dust from getting inside of the projector. In order to care for the projector appropriately, regular cleaning is required. Remove any dirt or dust that has accumulated on the projector and on or in the filter. When the "Please clean filter" message is displayed, stop using the projector immediately and clean or replace the filter. Blocking the air vents and leaving the projector uncleaned for a long time may not only damage the projector and may require costly repairs but may also cause accidents or fire. For maintenance of the filter, refer to "Option" on page 83 and "Replacing the Filters" on pages 97 - 98. Damages to the projector caused by using an un-cleaned filter or improper maintenance will void the warranty on the projector. Installing the Projector in Proper Position Install the projector properly. Improper installation may reduce the lamp lifetime and cause a fire hazard. Do not tilt the projector more than 10 degrees above and below. NO UPWARD NO DOWNWARD Do not point the projector up to project an image. Do not point the projector down to project an image. NO SIDEWAYS Do not put the projector on either side to project an image. iii