Sharp A260 Service Manual - Page 3

CHAPTER 1. GENERAL DESCRIPTION [1] Specifications Automatic dialing: 40 numbers Imaging film: Initial starter roll: (included with machine): 32 ft. (10 m) (approx. 30 letter-size pages) Replacement roll (not included): UX-5CR 164 ft. (50 m) roll (one roll yields approx. 150 letter-size pages) Memory size* : 448 KB (approx. 24 average pages with no voice messages recorded, or 20 minutes of voice message (including OGMs) with no documents in memory) Modem speed: 14,400 bps with automatic fallback to lower speed Transmission time* : Approx. 6 seconds (only when ECM is on) Resolution: Horizontal: 203 pixels/inch (8 dots/mm) Vertical: Standard: 98 lines/inch (3.85 lines/mm) Fine/Halftone: 196 lines/inch (7.7 lines/mm) Super fine: 391 lines/inch (15.4 lines/mm) Automatic document feeder: 10 pages max. (letter/A4, 20 lb paper) Recording system: Thermal transfer recording Halftone (grayscale): 64 levels Compression scheme: MH, MR, MMR Display: 16-digit LCD display Applicable telephone line: Public switched telephone network Paper tray capacity: Letter: Approx. 50 sheets (20-lb. copier paper at room temperature; maximum stack height should not be higher than the line on the tray) Legal: 5 sheets Recommended paper weight is 20-lb. Copy Bond UX-A260U Compatibility: ITU-T (CCITT) G3 mode Input document size: Automatic feeding: Width: 5.8 to 8.5" (148 to 216 mm) Length: 5.5 to 11" (140 to 279 mm) Manual feeding: Width: 5.8 to 8.5" (148 to 216 mm) Length: 5.5 to 23.6" (140 to 600 mm) Effective scanning width: 8.3" (210 mm) max. Effective printing width: 8.3" (210 mm) max. Contrast control: Automatic/Dark selectable Reception modes: TEL/FAX/TAD Copy function: Single/Multi (99 copies/page) Telephone function: Yes (cannot be used if power fails) Power requirements: 120 V AC, 60 Hz Operating temperature: 41 - 95°F (5 - 35°C) Humidity: 25 - 85 % RH Power consumption: Stand-by: 3.6 W Maximum: 100 W Dimensions (without attachments): Width: 12.9" (327 mm) Depth: 7.6" (193 mm) Height: 6.4" (163 mm) Weight (without attachments): Approx. 6.2 lbs. (2.8 kg) * Based on Sharp Standard No.1 Chart at standard resolution, excluding time for protocol signals (i.e., ITU-T phase C time only). justmanuals.com As a part of our policy of continuous improvement, SHARP reserves the right to make design and specification changes for product improvement without prior notice. The performance specifications figures indicated are nominal values of production units. There may be some deviations from these values in individual units. 1 - 1