Sharp CD-DK890N CD-DK890N Operation Manual - Page 11

Antenna connection Supplied FM antenna: Connect the FM antenna wire to the FM 75 OHMS jack and position the FM antenna wire in the direction where the strongest signal can be received. FM antenna AM loop antenna Supplied AM loop antenna: Connect the AM loop antenna to the AM and GND terminals. Position the AM loop antenna for optimum reception. Place the AM loop antenna on a shelf, etc., or attach it to a stand or a wall with screws (not supplied). Note: Placing the antenna on the unit or near the AC power cord may cause noise pickup. Place the antenna away from the unit for better reception. Installing the AM loop antenna: < Assembling > < Attaching to the wall > Wall Screws (not supplied) Speaker connection Connect the black wire to the FRONT SPEAKERS minus (-) terminal, and the red wire to the FRONT SPEAKERS plus (+) terminal. CD-DK890N Caution: Use speakers with an impedance of 6 ohms or more, as lower impedance speakers can damage the unit. Do not mistake the right and the left channels. The right speaker is the one on the right side when you face the unit. Do not let the bare speaker wires touch each other. Do not stand or sit on the speakers. You may be injured. Do not allow any objects to fall into or to be placed in the bass reflex duct. Incorrect Connecting iPod to a TV The iPod with photo and video can be viewed by connecting to a TV/ monitor. If the TV/monitor has a video input, connect it to the VIDEO OUT jack on the rear of the unit. Preparation for Use Video cable TV (not supplied) To video input jack AC INPUT Note: Please make sure to set iPod unit to either NTSC or PAL to match your TV signal. Please visit Apple's home page for further information. Red AC INPUT Black 11