Sharp CD-DK890N CD-DK890N Operation Manual - Page 32

CD-DK890N Listening to a cassette tape (TAPE 1 or TAPE 2) Before playback: For playback, use normal or low-noise tapes for the best sound. (Metal or CrO tapes are not recommended.) Do not use C-120 tapes or poor-quality tapes, as they may cause malfunctions. Before loading a tape into the cassette compartment, tighten the slack with a pen or a pencil. POWER ON/ STAND-BY 5 4 3 2 1 TIMER CD 5 4 3 2 1 Tape playback 1 Press the ON/STAND-BY button to turn the power on. 2 Open the cassette compartment by pushing the area marked " ". 5 CD 4 3 2 1 PLAYBACK (PLAY & STOP) PHONES AUDIO IN RECORD/PLAYBACK 5 CD 4 3 2 1 PLPALYABYBAACCKK(P(PLALAYY&&SSTTOOPP) ) PHONES AUDIO IN RECORD/PLAYBACK RECORD/PLAYBACK 3 Load a cassette into the TAPE 1 compartment or TAPE 2 compartment with the side to be played facing toward you. C 4 3 2 1 PLPALYABYABCAKC(KPL(PALYA&YS&TSOTPO) P) PHONES AUDIO IN RERCOECRODR/PDL/APYLBAAYCBKACK 4 Press the TAPE (1 2) button to select the cassette you want to listen to. Tape Playback PLAYBACK (PLAY & STOP) PHONES AUDIO IN RECORD/PLAYBACK 5 Press the / (TAPE ) button to start playback. Tape play indicator Auto power on function: When you press any of the following buttons, the unit turns on. TAPE (1 2) button (main unit and remote control): The unit turns on and the "TAPE" function is activated. TAPE button (remote control): The unit turns on and the "TAPE" function is activated. / button (main unit): The unit turns on and playback of the last function starts (CD, TAPE, TUNER, AUDIO IN, iPod). Auto power off function: In the stop mode of tape operation, the main unit enters the stand-by mode after 15 minutes of inactivity. 32