Sharp MX-M464N Operating Guide - Page 751

SYSTEM SETTINGS Image Send Settings Settings related to the image send function (scan, Internet fax, etc.) can be configured. Touch the [Image Send Settings] key to configure the settings. For explanations of settings related to the fax function, see "SYSTEM SETTINGS FOR FAX" (page 7-104). Operation Settings The operation settings below apply to all image send functions. Other Settings Default Display Settings You can select one of 5 base screen types for the base screen that appears when the [IMAGE SEND] key is touched or when the [CLEAR ALL] ( ) key is pressed in image send mode. • Address Book • Scan • Internet Fax • Fax • Data Entry Hold address for a while after scanning has been completed Use this setting to hold the address after transmission is completed (until Auto Clear Mode Activates). Configure the setting for each of the following items: • E-mail • FTP/Desktop • Network Folder • Internet Fax (Including Direct SMTP) • Fax Address Book Default Selection One of the following screens can be specified for the initial address book screen. Tab Switch • ABC • Group Address Type • All • E-mail • FTP/Desktop • Network Folder • Internet Fax (Including Direct SMTP) • Fax • Group Image Orientation Sets the default image orientation. Initial Resolution Setting The following settings are available for the default resolutions of scan, Internet fax, and fax mode. Scan : 100X100 dpi, 200X200 dpi, 300X300 dpi, 400X400 dpi, 600X600 dpi Internet fax : 200X100 dpi 200X200 dpi 200X400 dpi 400X400 dpi Half Tone 600X600 dpi Fax: Standard Fine Super Fine Ultra Fine Half Tone Apply the Resolution Set when Stored When an image stored by document filing is used, this applies the resolution setting that was stored with the image. 7-81 Contents