Sharp PG-D120U PG-D120U Operation Manual - Page 16

Connecting to the Computer RGB Input/Output Terminals You can connect your projector to a computer for easy projection of full-color computer images, and an external monitor for simultaneous viewing. 1 Side view of the projector 1. Connecting to an IBM-PC (VGA, SVGA, XGA) Series computer - 1,024 × 768 IN COMPUTER RGB OUT RGB Signal Input Socket maximum resolution Plug the RGB signal cable correctly into the RGB INPUT terminal on the projector and into the RGB signal output terminal on the computer, and secure the plugs by tightening the thumb screws. RGB Signal Cable (Supplied) ANALOG RGB OUT IBM-PC (VGA, SVGA, XGA) Series (computer) Note: • This connection is possible only when using a computer with a VGA/SVGA/XGA or Mac display output port. RGB Signal Output Socket 2 1 Macintosh Adaptor (Supplied) Macintosh ANALOG RGB OUT RGB Signal Output Socket 2. Connecting to a Macintosh Series Computer • 640 × 480 resolution 1 First, connect the supplied Macintosh adaptor to the RGB signal output terminal on your Macintosh Series computer, as shown on the left, and secure the plugs by tightening the thumb screws. 2 Side view of the projector IN COMPUTER RGB OUT RGB Signal Input Socket Macintosh RGB Signal Output Socket ANALOG RGB OUT RGB Signal Cable (Supplied) 2 Next, firmly plug the supplied RGB signal cable into both the RGB input terminal on the projector and the Macintosh adaptor on the computer, and secure the plugs by tightening the thumb screws. • 832 × 624 resolution When connecting in the 832 × 624 dot mode, use a Macintosh adaptor with display mode switching function available from your local computer dealer. E-16