Sharp PG-D120U PG-D120U Operation Manual - Page 20

Basic Operation of the Projector 1 1. Connect the AC cord OFF ON 2 Open the socket cover and connect the supplied AC cord MAIN POWER switch to the socket. 1 AC cord 2 OFF POWER ON LAMP TEMP. When the MAIN POWER is on, the POWER indicator lights red. 2. Turn on the MAIN POWER Turn the MAIN POWER switch on the side of the projector. The POWER indicator lights red and the projector enters STANDBY mode. 3 Projector Remote control ON/OFF ON/OFF ON OFF POWER LAMP TEMP. When the power is on, the LAMP REPLACEMENT indicator flashes to show the operating condition of the lamp. Green: Lamp is ready Flashing green: Warming up Red: Change bulb 3. Turn on the POWER Press the POWER ON/OFF button on the projector or the POWER ON button of the remote control. • When the power is turned off by pressing the POWER ON/OFF button, the POWER indicator will not turn off until the fan has stopped running. • See page 31, "Lamp/Maintenance Indicators" for details. Notes: • When the POWER indicator is not lit, the remote control cannot be used to operate the projector. • If the power is turned on immediately after it has been turned off, it may take a short while before the lamp turns on. (During this period the LAMP REPLACEMENT indicator flashes.) • After the projector is unpacked and turned on for the first time, a slight odor may be emitted from the exhaust fan. This odor will soon disappear with use. 4 E-ZOOM (ON) E-ZOOM (OFF) 4. E-ZOOM Function This projector has an E-ZOOM mode which enlarges the display when inputting an image of less than 800 × 600 dots in size. The E-ZOOM button of the remote control is used to operate E-ZOOM function. See page 26, "E-ZOOM Function" for details. Notes: • E-ZOOM function does not operate with monochrome images or in SVGA (800 × 600), Mac 16" (832 × 624), NTSC, PAL or SECAM INPUT mode. • The picture size differs in RGB, NTSC, PAL and SECAM INPUT modes. E-20