Sharp PG-D120U PG-D120U Operation Manual - Page 27
Functions on the Projector
UPC - 074000347502
View all Sharp PG-D120U manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 27 highlights
Functions on the Projector Setting Up the System • Using this function, you can check the input signal and select the remote mouse. On-Screen Display SYSTEM SETUP RESOLUTION HOR FREQ VERT FREQ REMOTE MOUSE 800×600 3 7 . 9 KHz 6 0 Hz [AT] Checking the system • Press the MENU button. Select SYSTEM SETUP with the ADJUSTMENT / buttons. Then press the ENTER button to change to the picture indicated on the left. • The current system conditions will be displayed on the screen. • Press the MENU button to select the normal screen mode. :SEL. :ADJ. MENU : E N D Note: In the video screen, the resolution and frequency settings will not be displayed. SYSTEM SETUP RESOLUTION HOR FREQ VERT FREQ REMOTE MOUSE 800×600 3 7 . 9 KHz 6 0 Hz [AT] :SEL. :ADJ. MENU : E N D Selecting the Remote Mouse • Press the MENU button. • Select SYSTEM SETUP with the ADJUSTMENT / buttons. Then press the ENTER button. • Select REMOTE MOUSE and then select either [AT] or [98] with the ADJUSTMENT / buttons. • Select [AT] when using IBM compatibles and Apple Macintosh series. • Select [98] when using NEC PC98 series (for Japan). • Press the MENU button to select the normal screen mode. © RGB ADJ. RGB INPUT ADJ. IMAGE ADJ. AUDIO SYSTEM SETUP LANGUAGE :SEL. ENTER : N E X T MENU : E N D © RGB ADJ. PICTURE 0- + BRIGHT 0- + RED 0- + BLUE 0- + RESET MEMORY SELECT :SEL. ENTER : N E X T MENU : E N D © MEMORY SELECT 0 1 2 3 4 5 6 7 SETTING :SEL. ENTER : B A C K MENU : E N D © MEMORY SELECT 0 1 2 3 4 RESOLUTION HOR FREQ VERT FREQ SETTING 5 6 7 800×600 3 8KHz 6 0Hz :SEL. :ADJ. ENTER : E N T E R MENU : E N D Checking the Lamp Usage Time The lamp usage time can be checked at the On-Screen Display. 1 Press the INPUT SELECT button on the projector or remote control and select RGB INPUT. 2 Press the ENTER button to select the Memory Adjustment mode. • Press the MENU button. While the MENU screen is displayed, press the ADJUSTMENT / buttons to select "RGB ADJ." Press the ENTER button. The MENU mode changes as shown. • While the RGB adjustment menu is displayed, press the ADJUSTMENT / buttons to select "MEMORY SELECT." Then press the ENTER button to change the image. 3 Press the ADJUSTMENT / buttons and ENTER buttons. • The screen shown on the left will appear. • Press the ADJUSTMENT button once to move to the following screen. • Using the ADJUSTMENT / buttons, select memory no. "1" and then press the ENTER button. Then, repeating the same procedure for each number separately, enter "7," "0," "1," "0," and "0." 4 The lamp usage time will be displayed at the OnScreen Display for approximately 30 seconds. LAMP 0000H E-27