Sharp SR3U Operation Manual - Page 20

Major Components Front display CHANNEL panel ' /" Operating a TV Using the Remote Control (Universal Remote Control) The Universal Remote Control may operate the basic functions of 21 different types of TVs. To enter the Manufacturer's Code for your TV, follow the instructions below. There is no guarantee that the universal remote control will function with your TV. Setting the Manufacturer's Code 1 Press POWER and CH ' of TV CONTROL simultaneously. 2 Enter the 2-digit Manufacturer's Code with the Number buttons (Ex. 02-"0", "2") within 10 seconds after releasing POWER and CH ' of TV CONTROL. 3 Point the remote control unit towards the TV and then press POWER of TV CONTROL. • If the TV turns on/off, setup was successful. If not, repeat the proce- dure using another code. See the list below for the Manufacturer's Code and the buttons which work with each brand. Buttons on the Remote Brand EMERSON FISHER FUNAI GE GOLDSTAR HITACHI JVC MAGNAVOX MITSUBISHI PANASONIC PIONEER RCA SAMSUNG SANYO SHARP SONY TECHNOL ACE TOSHIBA ZENITH Code 19 17 06 07, 09 18 15 16 09 11 14 13, 21 03 07, 09 20 17 01 02 10 04 12 05 08 POWER CH '/" VOL / INPUT NOTE • If the batteries in the remote control unit are changed, the code settings must be reentered. • Some brands have more than one code listed above, due to changes in the codes. In such cases, try another code to find the code that operates your TV. Setting the Remote Control Code • Two types of remote control codes operate this Recorder: RC-1 and RC-2. If you operate this Recorder by remote control along with another SHARP DVD recorder or DVD player placed next to it simultaneously, switching the remote control code (both the Recorder and remote control) to one of the signals (RC-1 or RC-2) will let you operate only with this Recorder. • Make sure to set the Recorder and remote control to the same remote code. You can not operate the Recorder if they are not set to the same code. Setting the Remote Control Code of the Remote Example: Setting the code to "RC-2". 1 Press and hold POWER and 2 together for more than 5 seconds. 2 Press POWER of this Recorder to see if you can turn it on/off. • If you cannot, go to step 3. NOTE • The remote control code of the remote becomes "RC-1" when you change the batteries. Setting the Remote Control Code of the Recorder 3 Press POWER to turn off the Recorder. 4 Press and hold CHANNEL" and ' on the Recorder together for more than 5 seconds. • Each time this operation is performed, the code of the Recorder toggles between "RC-1" and "RC-2". The front panel display changes as the code changes. • Press POWER on the remote control to see if you can turn on/off the Recorder. If remote control does not work Press POWER on the remote control and check the front panel display (RC-1 or RC-2). Set the remote control code according to the display and press POWER to see if you can turn on/off the Recorder. 20