Sharp SR3U Operation Manual - Page 25
EZ Set Up
![]() |
UPC - 074000354371
View all Sharp SR3U manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 25 highlights
EZ Set Up Important! (Caution during EZ Set Up): • Do not press POWER on the Recorder or remote control. The EZ Set Up function automatically sets the tuner channels and clock when the antenna cable is connected to the rear of the Recorder and the power plug is then connected to an AC outlet. POWER Important! When using a cable box: • See "CATV or Satellite Receiver Connections" on pages 23 and 24. • Leave power on the cable box turned on and select a channel that carries EDS signals. 1 Make sure that the antenna cable is connected. For connection configuration, refer to "Basic Connection" on page 21. 2 Connect the power plug of the Recorder to an AC outlet. 3 The tuner channels and clock will automatically be set. • This Recorder can monitor and use time-signals (EDS signals), which are provided by some TV stations, to automatically adjust the clock. This Recorder automatically searches EDS signals, but if you are in a hurry to use timer recording or know the channel of the EDS signal carrier in your area, follow the procedure in "Auto Clock Setting" (page 29) or "Manual Clock Setting" (page 30). During Auto Channel Setting During Auto Clock Setting EZ Set Up complete • Channel number is increasing. NOTE • If power is supplied to the Recorder before the cable is connected, EZ Set Up will not be able to preset the channels into memory. If this occurs, press RESET inside the front door of the Recorder (see page 17). The EZ Set Up function will work again. • If the power is turned on during EZ Set Up, Auto Channel Setting will be interrupted and the tuner channels will not be preset. • Auto Clock Setting may take several minutes. • If Auto Clock Setting is not completed within 30 minutes, there may be no channels with EDS signals. In this case, set the clock manually. (See "Manual Clock Setting" on page 30.) • If the antenna signal is weak, the Auto Clock Setting function may not operate. • During initial channel setting, the channels are set into the AIR channel setting. To watch CATV channels, select "CATV" on the "CHANNEL PRESET" screen. (See "Channel Setting" on page 31.) Turning the Power On After finishing EZ Set Up, press POWER on the remote control or Recorder to turn on the power of Recorder. • When the Recorder power is turned on for the first time after purchase, following EZ Set Up, the OSD LANGUAGE Select screen is displayed and the Connection Guide function will then operate. Follow the procedure shown on pages 26 and 27. From the second time on, the OSD LANGUAGE Select screen will not appear after EZ Set Up. To Turn the Power Off Press POWER on the remote control or Recorder to turn off power. • The STANDBY indicator will light up. • If you press POWER again immediately after turning off, the Recorder may not turn on. If this happens, wait a while and then turn on power again. About the Power Supply • Do not unplug the power cord immediately after you plug it into the AC outlet (less than about 15 seconds after plugging in). In very rare cases, this may cause the memory to revert to its initial state, and all timer programs will be erased. If this happens, EZ Setup will be performed automatically. 25
![](/manual_guide/products/sharp-sr3u-operation-manual-2dbbc72/25.png)