Sharp SR3U Operation Manual - Page 34

Recording to DVD Checking Remaining Time and Other Information Press ON SCREEN (under the cover) during DVD playback or recording. • Disc capacity and the number of recorded titles, etc. are displayed. It is recommended to confirm before recording. DVD-RW VR ORIG IN AL F I NE REMAIN 0h30m 2 10 00 : 00: 00 Disc capacity Number of titles Number of chapters Loading Disc 1 Press POWER to turn the power on. 2 Press OPEN/CLOSE on the Recorder to open the disc tray. OPEN/CLOSE 3 Load disc on the disc tray. • "REMAINING 0h0m" will be displayed when an unrecordable disc is set. NOTE • Disc remaining time display is approximate measure of disc capacity. There may be space left in disc capacity after recording. (Remaining time during recording and after recording might not be the same.) Not Enough Disc Capacity • Exact Recording (page 76) Exact recording functions when the selected recording mode is not appropriate to fit the program to the disc when you timer record. Cutting TV Commercials (page 60) • You cannot cut scenes when you record programs by Video mode to DVD-RW or DVD-R. Tamper Proof • You can set Tamper Proof to prevent operations by mistake during recording or timer recording. 1 Press and hold TAMPER PROOF (ON SCREEN and DISPLAY together) for more than 2 seconds. 2 Each time you perform this operation, the function is activated or deactivated. • If you try to operate the Recorder while Tamper Proof is set, " " blinks in the front display panel and tells you that Tamper Proof is set. • Insert the disc with the label face up. • In case of disc recorded on both sides, face the side you want to record down. 4 Press OPEN/CLOSE to close the disc tray. Direct Recording to DVD DVD-RW DVD-RW DVD-R VR MODE VIDEO MODE Explained below is the standard procedure for recording the program being viewed onto DVD. • You can create a maximum of 99 original titles. • Record in VR mode when you want to edit later. Edit functions will be limited when you record in Video mode. Preparation for Direct Recording • When you record SAP broadcast, set "SAP SETTING" to "ON" (see page 76). 1 1 Turn on the power of TV. • When the recorder is connected to other audio equipment, turn them on as well. 2 Set the TV input mode to the mode the recorder is set to. 2 Press POWER to turn on the recorder. 3 Set a DVD-RW or DVD-R disc. • When a new DVD-RW disc not initialized yet is set, VR mode initializing starts automatically. When initializing is over, you can start recording. • When you want to re-initialize in Video mode, select "VIDEO MODE INIT." screen (page 84). • When you want to initialize in Video mode from the beginning, select "AUTO INITIALIZE" screen (page 84). 34