Sharp XL-S10 XL-S10 Operation Manual - Page 15

To interrupt playback: Main unit operation: Press the button. To resume playback from the same point, press the button again. Remote control operation: Press the button. To resume playback from the same point, press the To stop playback: Press the button. button. To remove the CD: While in the stop mode, press the CD EJECT button. After use: Press the ON/STAND-BY button to enter the power stand-by mode. Caution: ! If a disc is damaged, dirty, or loaded upside down, "no dISC" will appear on the display. ! Keep foreign objects out of the CD compartment. ! Subjecting the unit to shock or vibration may cause mistracking. ! When the unit is not being used, be sure to close the CD com- partment. If it is left open, the lens may be covered with dust and the unit may not operate properly. ! If TV or radio interference occurs during CD operation, move the unit away from the TV or radio. " To locate the beginning of a track To move to the beginning of the next track: Press the button for less than 0.5 seconds during playback. ! You can skip to any track by pressing the button repeatedly until the desired track number appears. To restart the track being played: Press the button for less than 0.5 seconds during playback. ! You can skip to any track by pressing the button repeatedly until the desired track number appears. " To locate the desired portion For audible fast forward: Press and hold down the button on the main unit or the button on the remote control during playback. For audible fast reverse: Press and hold down the button on the main unit or the button on the remote control during playback. Notes: ! Normal playback will resume when the ( ) or ( ) but- ton is released. ! When the end of the last track is reached during fast forward, "End" will appear on the display and CD operation will be paused. When the beginning of the first track is reached during fast reverse, the disc will start playback automatically. CD Playback XL-S10 15