Singer 1 One Instruction Manual 34 - Page 32

21. Two or three-thread pin tucking Pin tucking is a useful decoration when sewing blouses and children's clothes. Pin tucking is accomplished before cutting out garment. • Use ordinary overedge throat plate or rolled hemming throat plate. • Remove left needle. • Before sewing on your garment, always make a test stitch on a sample of your fabric so that you can adjust the thread tensions correctly for standard 1 needle, 3 thread overedge stitching, or 1 needle 2 thread wrapped edge overlock stitching. • Place movable knife in non-operating position. (see page 21) • Fold fabric in half with the wrong side facing up. • Place fabric under the foot with the fold resting against the wall of edge guide. • Adjust edge guide so that the stitches will just overcast the edge of the fold as shown in the sketch. • Lower the foot and sew. When stitching is completed, press pin tuck to lay flat on one side. 1 1 22. Reinforced (tapes) overedge stitching (14U286B) Inserting a tape while overedge stitching, will give a much more durable seam. a. Remove front cover screw (1) and install tape guide attachment. b. Pass tape as shown in figure through tape guide 0 , tape guide 0 , hole ® in presser foot and draw to rear from under presser foot. T Tape guide Hole Front cover screw 0 30