Singer 1 One Instruction Manual 34 - Page 9

Preparation, threading

Get Singer 1 One PDF manuals and user guides View all Singer 1 One manuals
Add to My Manuals
Save this manual to your list of manuals

Page 9 highlights

5. Preparation for threading • Setting up the thread guide holder Thread guide holder Thread guide Extend the thread guide holder as far as possible and set the thread guides so that they are located right above the spool pins. Place the thread on the spool stand as shown above. Spool el stand • How to insert the needles Use Singer needles Cat. No. 2054 available in sizes #14 and #10 To remove the needles: • Be sure the power line plug is disconnected from the wall receptacle. • Turn the hand wheel toward you until the needle is at its highest position. Loosen the needle set screw with a screwdriver and remove needles. To replace the needle: • Insert the needles into the needle bar hole as far as they will go with flat surface to the rear and securely tighten the needle set screw. Left needle set screw Replace SD Right needle set screw Remove Flat surface to the rear } Note: When both the left and right needles are inserted, the left needle will be slightly higher than the right. 7

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
5.
Preparation
for
threading
•
Setting
up
the
thread
guide
holder
Thread
guide
Thread
guide
holder
el
Spool
stand
Extend
the
thread
guide
holder
as
far
as
possible
and
set
the
thread
guides
so
that
they
are
located
right
above
the
spool
pins.
Place
the
thread
on
the
spool
stand
as
shown
above.
•
How
to
insert
the
needles
Use
Singer
needles
Cat.
No.
2054
available
in
sizes
#14
and
#10
To
remove
the
needles:
•
Be
sure
the
power
line
plug
is
disconnected
from
the
wall
receptacle.
•
Turn
the
hand
wheel
toward
you
until
the
needle
is
at
its
highest
position.
Loosen
the
needle
set
screw
with
a
screwdriver
and
remove
needles.
To
replace
the
needle:
•
Insert
the
needles
into
the
needle
bar
hole
as
far
as
they
will
go
with
fl
at
surface
to
the
rear
and
securely
tighten
the
needle
set
screw.
Left
needle
set
screw
Replace
Remove
SD
Right
needle
set
screw
Flat
surface
to
the
rear
}
Note:
When
both
the
left
and
right
needles
are
inserted,
the
left
needle
will
the
right.
be
slightly
higher
than
7