Snapper 200Z Operater's Manual - Page 22
Washing the Mower Deck, Storage
View all Snapper 200Z manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 22 highlights
Maintenance Washing the Mower Deck The washout port allows you to connect a typical garden hose to the trim side (L.H.) of the mower deck to remove grass and debris from the underside of the deck. This ensures proper and safe operation of the mower. 1. Park the rider on a smooth, level surface such as a concrete floor. Disengage the PTO, lock the ground speed levers into their START/PARK positions, engage the parking brake, turn off the engine, and remove the ignition key. WARNING Before running the mower, make sure the hose is properly connected and does not come into cotact with the blades. When the mower is running and the blades are engaged, the person cleaning the mower must be in the operator position, and there must be no bystanders. Failure to follow these precautions may result in serious injury or death. 2. Attach the quick disconnect (A, Figure 12) to a gar- Storage den hose (B), and connect to the washout port (C) on the mower deck. Before you store your unit for the off-season, read the Maintenance and Storage instructions in the Operator 3. Turn on the water. Safety section, then perform the following steps: 4. Start the engine, set the mower deck in the highest cutting position, and engage the PTO to remove grass and debris from the underside of the mower • Disengage the PTO, move the ground speed levers into the START/PARK positions, set the parking brake, & remove the key. deck. 5. Disengage the PTO, turn off the engine, and remove r n the ignition key. fo tio 6. Remove the garden hose and quick disconnect from the mower deck when cleaning is completed. ot c A N du B ReproWARNING C • Perform engine maintenance and storage measures listed in the engine owner's manual. This includes draining the fuel system, or adding stabilizer to the fuel (do not store a fueled unit in an enclosed structure - see warning). • Battery life will be increased if it is removed, put in a cool, dry place and fully charged about once a month. If the battery is left in the unit, disconnect the negative cable. Before starting the unit after it has been stored: • Check all fluid levels. Check all maintenance items. • Perform all recommended checks and procedures found in the engine owner's manual. • Allow the engine to warm up for several minutes before use. Never store the unit (with fuel) in an enclosed, poorly ventilated structure. Fuel vapors can travel to an ignition source (such as a furnace, water heater, etc.) and cause an explosion. Fuel vapor is also toxic to humans and animals. Figure 12. Mower Deck Washout Port 22 www.Snapper.com