Snapper SPX2042 Operation Manual - Page 21
Changing the Engine Oil
View all Snapper SPX2042 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 21 highlights
Changing the Engine Oil WARNING Fuel and its vapors are extremely flammable and explosive. Fire or explosion can cause severe burns or death. When Changing Oil • If you drain the oil from the top oil fill tube, the fuel tank must be empty or fuel can leak out and result in a fire or explosion. 1. Run engine until warm. 2. Place the tractor on a level surface (see Figure 4). 3. Stop the engine. 4. Clean oil fill and filter areas of any debris. Remove dipstick and lay on clean cloth (see Figure 5). 5. Disconnect the oil drain hose (see Figure 9). Carefully remove cap and lower hose into an approved container. After the oil has drained, install cap tightly, then attach the hose to the side of the engine. 6. Remove the oil filter and dispose of properly. r ction Figure10 fo u 7. Lightly lubricate the oil filter gasket with fresh, clean oil t d(see Figure 10). 8. Install the oil filter by hand until the gasket contacts the o ooil filter adapter, then tighten the oil filter 1/2 to 3/4 turns. N Repr9. Add oil (see Check and Add Engine Oil). Figure 9 en 21