Sony BDV-IS1000/C Operating Instructions - Page 101
Controlling the TV or Other Components with the Supplied Remote - codes
View all Sony BDV-IS1000/C manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 101 highlights
Note • When you perform [Auto Calibration] in the Easy Setup (page 60), the default settings are changed. • Depending on the input stream, [Distance] may not be effective. x [Level] You can adjust the sound level of the speakers, center speaker, and subwoofer. You can set the parameters from -6.0 dB to +6.0 dB. Be sure to set [Test Tone] to [On] for easy adjustment. [Front L/R] 0.0 dB: Set the front speaker level. [Center] 0.0 dB*: Set the center speaker level. [Surround L/R] 0.0 dB*: Set the surround speaker level. [Surround Back L/R] 0.0 dB*: Set the surround Back speaker level. [Subwoofer] 0.0 dB: Set the subwoofer level. * This item appears when you set to [Yes] in the [Connection] setting. x [Test Tone] The speakers will emit a test tone to adjust [Level]. [Off]: The test tone is not emitted from the speakers. [On]: The test tone is emitted from each speaker in sequence while adjusting level. When you select one of the [Speaker Settings] items, the test tone is emitted from each speaker in sequence. Adjust the sound level as follows. 1 Set the [Test Tone] to [On]. 2 Press C/X/x/c repeatedly to select the desired speaker and the level. 3 Press . 4 Repeat Steps 1 to 3. 5 Press C/X/x/c repeatedly to set [Test Tone] to [Off] after adjusting the speaker level. Note • The test tone signals are not output from the HDMI OUT jack. Tip • To adjust the volume of all the speakers at one time, press VOLUME +/-. Controlling the TV or Other Components with the Supplied Remote By adjusting the remote signal, you can control your TV, a Sony component (such as a VCR, DVD player/recorder, etc.), CATV, or set-top box/digital satellite receiver with the supplied remote. Note • When you replace the batteries of the remote, the code number may reset itself to the default (SONY) setting. Reset the appropriate code number. Other Operations Preparing the remote for controlling the components 1 Press POP UP/MENU while pressing TV (for TV) or STB (for a Sony component, CATV, set-top box/digital satellite receiver, etc.). TV or STB (pressed button) flashes. 2 While TV or STB is flashing, enter the manufacturer's code (see the table) using the number buttons, then press TIME. If you successfully set the manufacturer's code, TV or STB will flash twice slowly. If the setting is unsuccessful, TV or STB will flash five times quickly. Code numbers of controllable components If more than one code number is listed, try entering them one at a time until you find the code that works with your TV. TV Manufacturer SONY AIWA AKAI DAEWOO GE GOLDSTAR/LG Code number 5001 (default), 5002 5001 5003 5003, 5015, 5044 5003, 5009, 5010, 5044 5003, 5015, 5017, 5044, 5068 101US