Sony CPD-L133 Operating Instructions (primary manual) - Page 11
Eliminating, Flickering, Blurring, aOPTION
![]() |
View all Sony CPD-L133 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 11 highlights
Eliminating Flickering or Blurring If a part of the screen is flickering or blurring, press the AUTO button. If this operation does not work, adjust the Pitch and Phase as follows. Once the pitch and phase are adjusted, they will be stored in memory for the current input signal. 1 Load the Utility Disk (page 10). 2 Press the MENU button. The MENU OSD appears. MENU MENU OK-T#TJ ?z,ol At PHASE OID PITCH E'CENTER ZOOM IN COLOR aEOl LPATNIGOUNAGE 3 Press the 0/0 buttons to select PITCH, and press the MENU button again. The PITCH OSD appears. *Lti MENU PITCH 0 0 1328 C Customizing Your Monitor 6 Press the 0/0 buttons to select PHASE, and press the MENU button again. The PHASE OSD appears. MENUI:( / 01 O PHASE A 0 26 C 7 Press the +/- buttons until the screen color becomes uniform. If you are using the Utility Disk, adjust until the horizontal stripes are at a minimum. Lti The OSD automatically disappears after about 30 seconds. To dose the OSD, press the MENU button again. To turn off the test pattern, click MO on the screen. 4 Press the +/- buttons until the screen color becomes uniform. If you are using the Utility Disk, adjust so that the vertical stripes disappear. u- 5 Press the MENU button. The MENU OSD appears. If horizontal stripes are observed over the entire screen, adjust the Phase in the next step. 11
![](/manual_guide/products/sony-cpdl133-operating-instructions-primary-manual-d6faab6/11.png)