Sony CPD-L133 Operating Instructions (primary manual) - Page 5
Setup
View all Sony CPD-L133 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 5 highlights
Getting Started Setup Before using this monitor, check that the following items are included in your carton: • LCD monitor (1) • AC adaptor (1) 7- • Rear cover (1) • Power cord (1) • HD15 video signal cable (1) • Macintosh adapter (1) • Windows Monitor Information Disk/Utility Disk (1) • Macintosh Utility Disk (1) • TCO'95 Eco-document (1) • Warranty card (1) • These operating instructions (1) This monitor works with any IBM or compatible system equipped with VGA or greater graphics capability. Although this monitor works with other platforms running at horizontal frequencies between 30 and 70 kHz, including Macintosh and Power Macintosh systems, a cable adapter is required. Please consult your dealer for advice on which adapter is suitable for your needs. This monitor also can receive the RGB signals of the PAL and N'TSC systems. II 1 1.)i it tir ko t With the computer switched off, connect the video signal cable to the monitor using the supplied HD15 video signal cable. • If you are using an IBM PC/AT or compatible computer, refer to the section below. • If you are using a Macintosh or compatible computer, refer to the following section, "Connecting to a Macintosh or compatible computer." Connecting to an IBM PCJAT or compatible computer If your PC system is not compatible with DDC1 and DDC2B This monitor uses the No. 9 pin in the video signal connector for DDC1 and DDC2B compatibility. Some PC systems which are not compatible with either DDC1 or DDC2B may not accept the No. 9 pin. If you are not sure whether your PC system accepts the No. 9 pin or not, use the HD15 (Female) - HD15 (Male without the No. 9 pin) adapter (not supplied). Make sure the male side (without the No. 9 pin) is connected to the computer. Connecting to a Macintosh or compatible computer to HD15 Macintosh or compatible computer to monitor output HD15 video signal cable (supplied) . 0000 Macintosh adapter (supplied) About the supplied Macintosh adapter The supplied Macintosh adapter is compatible with Macintosh LC, Performa, Quadra and Power Macintosh series computers. Macintosh 11 series and some older versions of Power Book models may need an adapter with micro switches (not supplied). 4' 1,4 • so l ' With the monitor switched off, connect one end of the DC power cord to the monitor and the other end to a power outlet. t t to HD15 to a power outlet Power cord (supplied) AC adaptor (supplied) to DC IN IBM PC/AT or compatible computer 1h. 111 to monitor output HD15 video signal cable (supplied)