Sony DCR VX2100 Operating Instructions - Page 83

Editing Dubbing only desired scenes - Digital program editing (10)Turn the SEL/PUSH EXEC dial to select "CUT-IN," then press the dial. (11)Turn the SEL/PUSH EXEC dial to select the average numerical value of CUT-IN, then press the dial. The calculated start position for recording is set. (12)Turn the SEL/PUSH EXEC dial to select "CUT-OUT," then press the dial. (13)Turn the SEL/PUSH EXEC dial to select the average numerical value of CUT-OUT, then press the dial. The calculated stop position for recording is set. (14)Turn the SEL/PUSH EXEC dial to select RETURN, then press the dial. 10,11 OTHERS ED I T SET CONTROL ADJ TEST "CUT-I N" 0 "CUT-OUT" I R SETUP PAUSEMODE I R TEST RETURN [MENU] : END 12,13 OTHERS ED I T SET CONTROL ADJ TEST "CUT-I N" 0 "CUT-OUT" I R SETUP PAUSEMODE I R TEST RETURN [MENU] : END OTHERS ED I T SET CONTROL ADJ TEST "CUT-I N" "CUT-OUT" 0 I R SETUP PAUSEMODE I R TEST RETURN [MENU] : END OTHERS ED I T SET CONTROL ADJ TEST "CUT-I N" "CUT-OUT" 0 I R SETUP PAUSEMODE I R TEST RETURN [MENU] : END Errors in editing If you connect your camcorder to Sony equipment with the DV jack, the range of errors is within +/- 5 frames. The range may become wider in the following conditions: •The interval between CUT-IN and CUT-OUT is less than five seconds (p. 84). •CUT-IN or CUT-OUT is set at the beginning of the tape. When "ENGAGE REC PAUSE" appears on the LCD screen or in the viewfinder Turn the recording VCR to recording pause mode. Note If you start recording from the very beginning of the tape, the first few seconds of the tape may not record properly. Be sure to allow about 10 seconds' lead before starting the recording. 83