Sony DCR VX2100 Operating Instructions - Page 97
Audio dubbing, Adding an audio sound on a recorded tape, Monitoring the new recorded sound
![]() |
UPC - 027242639812
View all Sony DCR VX2100 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 97 highlights
Editing Audio dubbing Adding an audio sound on a recorded tape (1) Insert the recorded tape into your camcorder. (2) Set the POWER switch to VCR on your camcorder. (3) Locate the recording start point by pressing N. Then press X at the point where you want to start recording to set your camcorder to the playback pause mode. (4) Press AUDIO DUB. The green X indicator appears on the LCD screen or in the viewfinder. (5) Press X and start playing back the audio you want to record at the same time. The new sound is recorded in stereo 2 (ST2) during playback. (6) Press x at the point where you want to stop recording. AUDIO DUB POWER switch Monitoring the new recorded sound To play back the sound Adjust the balance between the original sound (ST1) and the new sound (ST2) by selecting AUDIO MIX in the menu settings (p. 109). VCR SET H i F i SOUND AUD I O M I X A/V DV OUT ST1 ST2 RETURN [MENU] : END If you wait five minutes after you disconnect the power source or remove the battery pack, the setting of AUDIO MIX returns to the original sound (ST1) only. The default setting is for original sound only. 97
![](/manual_guide/products/sony-dcr-vx2100-operating-instructions-c7b73c8/97.png)