Sony KDL 52W5100 Operating Instructions - Page 12

Shown with PC connection Use the TV as a monitor for your PC by connecting an HD15-HD15 cable connection as shown to the right. This TV can also be connected to a PC with a DVI or HDMI output. (Refer to the supplied Quick Setup Guide.) Side panel PC IN RGB HD15-HD15 cable (analog RGB) AUDIO 2 Audio cable IN (stereo mini plugs) IN 3 IN 4 S VIDEO VIDEO L (MONO) AUDIO R 2 VIDEO IN PC Input Signal Reference Chart After connecting the PC to the TV, set the output signal from your PC according to the supported resolutions and timings indicated below. Supported resolutions Signal VGA Horizontal × (Pixel) 640 × SVGA 800 × XGA 1,024 × WXGA 1,280 × 1,280 × 1,360 × SXGA 1,280 × HDTV* 1,920 × Vertical (Line) 480 600 768 768 768 768 1,024 1,080 Horizontal frequency (kHz) 31.5 37.9 48.4 47.4 47.8 47.7 64.0 67.5 Vertical frequency (Hz) 60 60 60 60 60 60 60 60 Standard VGA VESA Guidelines VESA Guidelines VESA VESA VESA VESA CEA-861* ~ • This TV's PC input does not support Sync on Green or Composite Sync. • This TV's PC VGA input does not support interlaced signals. • For the best picture quality, it is recommended to use the signals in the above chart. In plug and play, signals with a 60 Hz vertical frequency will be detected automatically. (PC reboot may be necessary.) * The 1080p timing when applied to the HDMI input will be treated as a video timing and not PC timing. This affects Picture settings and Wide Mode settings. To view PC content set Scene Select to Graphics, Wide Mode to Full, and Display Area to Full Pixel. • Connect the PC IN jack to the PC using an HD15-HD15 cable with ferrite core (analog RGB) and audio cable (see page 9). • The TV enters the standby mode automatically when the PC is connected to the TV and no signal has been output from the PC for more than 30 seconds, see the online Reference Book for details. 12