Sony KP-53HS10 Operating Instructions - Page 18

Connecting a DBS (Direct Broadcast Satellite) Receiver and VCR 1 Connect the cable from the satellite antenna to the satellite receiver. 2 Attach the coaxial cable from the incoming cable connection or antenna to VHF/UHF IN on the VCR. 3 Using a coaxial cable, connect VHF/UHF OUT on the VCR to VHF/UHF on the projection TV. 4 Using AUDIO and S VIDEO* cables, connect AUDIO and S VIDEO OUT on the DBS receiver to AUDIO and S VIDEO IN on the VCR. 5 Using AUDIO and S VIDEO* cables, connect AUDIO and S VIDEO OUT on the VCR to AUDIO and S VIDEO IN on the projection TV (White-AUDIO Left, Red-AUDIO Right). * If your VCR or DBS receiver is not equipped with S VIDEO, use a VIDEO cable (yellow) instead of the S VIDEO cable. Note: • To view input from the DBS or VCR, select the video input which your DBS receiver or VCR is connected to by pressing TV/VIDEO on the remote control. Disconnect all power sources before making any connections. S VIDEO (Rear of projection TV) CONTROL S IN OUT AUX IN OUT VIDEO 4 VIDEO 5 (DTV) SELECT IN VIDEO 1 VIDEO 3 HD VD Coaxial cable (not supplied) 3 SATELLITE IN LINE OUT VHF/UHF AUDIO R AUDIO L VIDEO S VIDEO IN OUT DBS S VIDEO VIDEO L (MONO) AUDIO R 5 Y Y/G L PB PB/B (MONO) PR PR/R R VHF/UHF VIDEO L AUDIO R 1 Satellite antenna cable COMPONENT AUDIO 4 VIDEO AUDIO-L AUDIO-R VMC-810S/820S (not supplied) YC-15V/30V (not supplied) VCR AUDIO R AUDIO L VIDEO LINE IN LINE OUT S VIDEO VHF/UHF OUT IN VMC-810S/820S (not supplied) Cable/ Antenna 2 YC-15V/30V (not supplied) 14