Sony MXD-D5C Operating Instructions - Page 44
Troubleshooting, CD player MD deck Others, After you, ve attempted the prescribed
View all Sony MXD-D5C manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 44 highlights
Additional Information Troubleshooting If you experience any of the following difficulties while using the deck, use this troubleshooting guide to help you remedy the problem. CD player section The player does not start playing. / Insert a CD. / Place the CD properly. / Clean the CD. / Moisture condensation has formed inside the deck. Take the CD out and leave the deck turned on for about an hour until the moisture evaporates. MD deck section The deck does not operate or operates poorly. / The MD may be damaged. Replace the MD. The deck does not play back. / Moisture has formed inside the deck. Take the MD out and leave the deck in a warm place for several hours until the moisture evaporates. / Press 1/u to turn the deck on. / Slide the MD into the disc slot with the label side up and the arrow pointing towards the opening. / Replace the disc with one that has been recorded. The deck does not record. / The MD is record-protected ("Protected" and "C11" alternate). Close the record-protect slot (see page 9). / Make connections properly to the sound source. / The sound source is not connected to the selected input connector. Select the correct input connector using INPUT. / The recording level is not adjusted properly. Adjust the recording level properly (see page 23). / A premastered MD is inserted. Replace it with a recordable MD. / There is not enough time left on the MD. Replace it with another recordable MD with fewer recorded tracks, or erase unnecessary tracks. / There has been a power failure or the AC power cord has been disconnected during recording. Data recorded to that point may be lost. Repeat the recording procedure. The deck does not edit. / Press PLAY MODE repeatedly until "PGM" and "SHUF" disappear. / Close the record-protect slot. The sound has a lot of static. / Strong magnetism from a television or a similar device is interfering with operations. Move the deck away from the source of strong magnetism. The three- or five-digit display appears. / The Self-Diagnosis Function is on. Check the table on page 51. Others No sound is output. / Make the connections properly. / Operate the amplifier properly. / When using the headphones, turn PHONE LEVEL to turn up the output level. The remote does not operate the deck. / Make sure that there is no obstacles between the deck and the remote. / Point the remote at the remote sensor on the deck. / Replace the batteries in the remote. After you've attempted the prescribed remedies If the deck still does not operate properly, or if other problems not described above occur, turn off the deck, then reinsert the plug into the power outlet. If the problem persists, reset the system as follows: 1 Turn off the deck and unplug the AC power cord. 2 Reinsert the plug into the power outlet while pressing down 1/u. Should any problem persist even after resetting the system, consult your nearest Sony dealer. 44