Sony PDWU1 User Manual (PDW-U1 Professional Disc Drive Unit Operation Manual F - Page 14

Names and Functions of Parts 2 Chapter Chapter 2 Names and Functions of Parts 2-1 Front Panel 1 2 3 4 5 ACCESS ERROR/ALARM DISC IN 6 Z EJECT 7 a (power) indicator Lights green when the 1 (power) button on the rear panel is on. b ACCESS indicator Flashes blue when the disc is being accessed from the computer. If the 1 (power) button on the rear panel is pressed, turning it off, then the unit goes into the standby mode. Note Do not press the 1 (power) button on the rear panel to turn off, or disconnect the power cord while the ACCESS indictor is flashing. Doing so may lead to a loss of data on the disc. c ERROR/ALARM indicator If a fault occurs in the unit, this lights continuously or flashes red, as shown in the following table. Indicator Meaning Lit continuously Condensation has occurred. Flashing four An error occurred times a second (principally a hardware default). Flashing once a An alarm not listed second above occurred. Note The indicator may flash or light only for five seconds depending on the alarm. You can check alarms generated by this unit, using the alarm log of the utility software. For details, refer to the help file of the utility software. If the indicator is flashing four times a second, and it is not possible to check the alarm log, a malfunction may have occurred. In this case, contact your Sony service representative. When the error is eliminated, the indicator goes off. d DISC IN indicator Lights green when a disc is loaded. e Manual eject mechanism When there is no power supply to the unit, to eject the disc, remove the cover over this 14 2-1 Front Panel