Sony SCD-C2000ES Operating Instructions - Page 16

To resume Continuous Play Press PLAY MODE repeatedly (or CONTINUE on the remote) in stop mode until "SHUF" and "PGM" disappear. Tip The program remains even after Program Play ends. Press N to play from the beginning of the program again. The program remains even if you stop play. Notes • If you turn off the player, disconnect the power cord, press A OPEN/CLOSE on the player, or switch the playback layer or area, the program will be erased. • If you switch the playback layer or area during Program Play, a single track only will be played back from its beginning, and then the program will be erased. Checking the contents of the program Before you start playing or while the player is playing, press CHECK on the remote repeatedly. Each time you press the button, the disc and track numbers will appear in the display in the programed order. If you press CHECK on the remote while the player is playing, the programed disc and track numbers will appear starting with the currently playing program step. Changing the contents of the program You can change the contents of the program in stop mode. To Erase a track Do the following: 1 Press CHECK on the remote repeatedly until the track number you want to erase appears. 2 Press CLEAR on the remote. Erase from the last track in the program Press CLEAR on the remote. Each time you press the button, the last track of the program is erased. Add a track to the Perform Steps 2 through 3. end of the program Erase all tracks Hold down CLEAR on the remote or x (for about 2 seconds) until "PGM CLEAR" appears in the display. 16US Enjoying a Multi-channel Super Audio CD - Multi-channel management function This player is equipped with a Multi-channel management function that sets the playback mode of the Super Audio CD by the DSD-DSP (built into the player) according to the layout or size of your speaker. Front speakers L R Center speaker Sub woofer L R Surround speakers To set the Multi-channel management function, select the appropriate preset playback mode (2 channel mode or Multi-channel mode), and then adjust the output level balance for each speaker (only in the case of Multi-channel mode). Notes • This features only work when you play the Super Audio CD. • You may not be able to adjust the output level balance depending on the speaker layout mode that you selected.