Sony SCD-C2000ES Operating Instructions - Page 22
Additional Information, Precautions
UPC - 027242686793
View all Sony SCD-C2000ES manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 22 highlights
7 Press ENTER to store the disc name. Repeat Steps 1 through 7 to assign disc names to other discs. Other operations To Do the following: Correct a wrong 1 Press m/M repeatedly until character the incorrect character flashes. 2 Press CLEAR on the remote to delete the incorrect character, then input the correct character. 3 Press ENTER on the remote to store the disc name. Erase a disc name 1 Insert or select the disc you want, then press NAME INPUT on the remote. 2 Press CLEAR on the remote repeatedly to delete all the characters. 3 Press ENTER on the remote. Erase all disc names 1 Turn off the player. 2 While holding down x, press POWER on the player. After "ERASING" is displayed, "ALL ERASE" appears in the display and all disc names are erased. Note You cannot use the Disc Name when you play the disc on other players. 22US Additional Information Precautions On safety • Caution - The use of optical instruments with this product will increase eye hazard. • Should any solid object or liquid fall into the cabinet, unplug the player and have it checked by qualified personnel before operating it any further. • AC power cord must be changed only at the qualified service shop. • The unit is not disconnected from the AC power source (mains) as long as it is connected to the wall outlet, even if the unit itself has been turned off. On power sources • Before operating the player, check that the operating voltage of the player is identical with your local power supply. The operating voltage is indicated on the nameplate at the rear of the player. • The player is not disconnected from the mains as long as it is attached to the mains, even if the player itself has been turned off. • If you are not going to use the player for a long time, be sure to disconnect the player from the mains. To disconnect the mains lead, grasp the plug itself; never pull the cord. On placement • Place the player in a location with adequate ventilation to prevent heat build-up in the player. • Do not place the player on a soft surface such as a rug that might block the ventilation holes on the bottom. • Do not place the player in a location near heat sources, or in a place subject to direct sunlight, excessive dust or mechanical shock. On operation • If the player is brought directly from a cold to a warm location, or is placed in a very damp room, moisture may condense on the lenses inside the player. Should this occur, the player may not operate properly. In this case, remove the disc and leave the player turned on for about an hour until the moisture evaporates. • During power on, some noise may be heard while the disc is being loaded into the Super Audio CD player. This is not a malfunction. On adjusting the volume Do not turn up the volume too much while listening to a portion with very low level inputs or no audio signals. If you do, the speakers may be damaged when a peak level portion is played.