Sony SRG120DU Product Manual (SRG-120DU Operation Guide) - Page 12

Setting the range of UP/DOWN movement +25° 0° -25° SYSTEM Menu Note When you turn the camera to the right or left beyond the 90° with the camera pointed downward by 25°, the camera may be caught on the lens, depending on the zoom position of the lens. D-ZOOM (digital zoom) You can set digital zoom to ON or OFF. When set to OFF, digital zoom does not operate, and only optical zoom is available. When set to ON, digital zoom takes over after optical zoom reaches MAX (12×). Up to 144× can be zoomed digitally. When digital zoom is available, the resolution decreases. IR-RECEIVE (infrared signal reception) When this is set to OFF, the camera does not receive the signal from the supplied infrared remote commander. Be sure to keep it set to ON when you use the supplied infrared remote commander. Note You cannot set IR-RECEIVE to OFF when you operate the menu using the supplied infrared remote commander. To set it to OFF, use the appropriate VISCA command. DISPLAY INFO When this item is set to ON, the message automatically appears for about 3 seconds on the monitor screen, when you perform the following operations using the supplied infrared remote commander. Message PRESET n: OK "n" is a preset position number of the infrared remote commander, between 1 and 6. RECALL n: OK "n" is a preset position number of the infrared remote commander, between 1 and 6. RESET n: OK "n" is a preset position number of the infrared remote commander, between 1 and 6. ONE PUSH WB: OP ONE PUSH WB: OK ONE PUSH WB: NG Remote control operation You have stored the camera settings to POSITION 1 to 6. You have read the camera settings stored in POSITION 1 to 6. You have reset the camera settings stored in POSITION 1 to 6 to the default settings. During the white balance adjustment in the ONE PUSH white balance mode, the message blinks on the screen. When white balance adjustment is correctly performed in ONE PUSH white balance mode, this message appears on the screen. If white balance adjustment is incorrectly performed in ONE PUSH white balance mode, this message flashes on the screen. 12