Sony SRG120DU Product Manual (SRG-120DU Operation Guide) - Page 18

Appendix Message List The following messages and indications may appear for this camera. Perform the following as necessary. Lamp display Lamp Meaning and solution When the power is turned on, the STANDBY lamp and POWER lamp are lit, flash together, or flash alternately. The SYSTEM SELECT switch or the BOTTOM switch is not set correctly. Check the setting of each switch. The STANDBY lamp is lit. If the camera is moved forcibly, or a finger or other object interferes with camera movement, the camera's built-in processor may fail to memorize the pan/tilt position. Press the PAN-TILT RESET button of the infrared remote commander to reset the pan/tilt position. Screen display Message PRESET n:OK ("n" is a preset position number between 1 and 16) RECALL n:OK ("n" is a preset position number between 1 and 16) RESET n:OK ("n" is a reset position number between 1 and 16) ONE PUSH WB:OP ONE PUSH WB:OK ONE PUSH WB:NG Meaning and solution This message appears for about 3 seconds when you store camera settings to POSITION 1 to 16. The preset position number of the infrared remote commander is POSITION 1 to 6. This message appears for about 3 seconds when you read the camera settings stored in POSITION 1 to 16. The preset position number of the infrared remote commander is POSITION 1 to 6. This message appears for about 3 seconds when you reset camera settings stored in POSITION 1 to 16. The preset position number of the infrared remote commander is POSITION 1 to 6. During the white balance adjustment in the ONE PUSH white balance mode, this message blinks on the screen. When the white balance adjustment has been done correctly in the ONE PUSH white balance mode, this message is lit on the screen. When the white balance adjustment has failed in the ONE PUSH white balance mode, this message blinks on the screen. 18