Sony STRDH830 Operating Instructions - Page 67
HDMI Settings menu, System Settings menu - compare
View all Sony STRDH830 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 67 highlights
HDMI Settings menu You can make the required settings for equipment connected to the HDMI jack. x Ctrl for HDMI (Control for HDMI) Lets you turn the Control for HDMI function on or off. For details, see "Preparing for the "BRAVIA" Sync" (page 56). • ON • OFF Note When you set "Ctrl for HDMI" to "ON", "Audio Out" may be changed automatically. x Pass Through Lets you output the HDMI signals to the TV even when the receiver is in standby mode. • ON: When the receiver is in the standby mode, the receiver continuously outputs HDMI signals from the receiver's HDMI TV OUT jack. • AUTO: When the TV is turned on while the receiver is in the standby mode, the receiver outputs HDMI signals from the receiver's HDMI TV OUT jack. Sony recommends this setting if you use a "BRAVIA" Sync compatible Sony TV. This setting saves power in the standby mode when compared with the "ON" setting. • OFF: The receiver does not output HDMI signals when the receiver is in the standby mode. Turn on the receiver to enjoy the connected equipment's source on the TV. This setting saves power in the standby mode when compared with the "ON" setting. Notes • This function is not available when "Ctrl for HDMI" is set to "OFF". • When "AUTO" is selected, it may take a little more time for the image and sound to be output to the TV than when "ON" is selected. • When the receiver is in standby mode, "A.STANDBY" appears on the display panel if "Pass Through" is set to "AUTO" or "ON". However, "A.STANDBY" will disappear when "Pass Through" is set to "AUTO" and no signals are detected. x Audio Out Lets you set the HDMI audio signals output from the playback equipment connected to the receiver via an HDMI connection. • AMP: The HDMI audio signals from the playback equipment is only output to the speakers connected to the receiver. Multi channel sound can be played back as it is. • TV+AMP: The sound is output from TV's speaker and the speakers connected to the receiver. Notes • The sound quality of the playback equipment depends on the TV's sound quality, such as the number of channels, and the sampling frequency, etc. If the TV has stereo speakers, the sound output from the receiver is also in stereo as that of the TV, even if you play back multi channel source. • When you connect the receiver to an image display equipment (projector, etc.), sound may not be output from the receiver. In this case, select "AMP". System Settings menu You can customize the settings of the receiver. x Auto Standby Lets you set the receiver switch to standby mode automatically when you do not operate the receiver or when there is no signals input to the receiver. • ON: Switches to standby mode after approximately 30 minutes. • OFF: Does not switch to standby mode. Adjusting Settings continued 67GB