Sony STRDH830 Operating Instructions - Page 78
Tuner, Channel Linear PCM only with an HDMI
View all Sony STRDH830 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 78 highlights
• Check that the selected digital audio input jack is not reassigned to other inputs (page 60). The left and right sounds are unbalanced or reversed. • Check that the speakers and equipment are connected correctly and securely. • Adjust the sound level parameters using the Speaker Settings menu. Dolby Digital or DTS multi channel sound is not reproduced. • Check that the DVD, etc. you are playing is recorded in Dolby Digital or DTS format. • When connecting the DVD player, etc., to the digital input jacks of this receiver, make sure the digital audio output setting of the connected equipment is available. • Set "Audio Out" to "AMP" in the HDMI Settings menu (page 67). • You can enjoy High Bitrate Audio (DTSHD Master Audio, Dolby TrueHD), Multi Channel Linear PCM only with an HDMI connection. The surround effect cannot be obtained. • Make sure you have selected the sound field for movie or music (page 51). • Sound fields do not function when DTS-HD Master Audio, DTS-HD High Resolution Audio or Dolby TrueHD with sampling frequency of more than 48 kHz are being received. Recording cannot be carried out. • Check that the equipment is connected correctly. • Select the source equipment using the input buttons (page 40). • Audio input signals via HDMI IN and DIGITAL IN jacks cannot be recorded. • Copyright protection to prevent recording is contained in the sources. In this case, you may not be able to record from the sources. A test tone is not output from the speakers • The speaker cords may not be connected securely. Check to see if they are connected securely and cannot be disconnected by pulling on them slightly. • The speaker cords may have short-circuit problem. A test tone is output from a different speaker than the speaker displayed on the TV screen • The speaker pattern set up is incorrect. Make sure that the speaker connections and the speaker pattern match correctly. When the receiver is in standby mode, there is no sound output from the TV. • When the receiver enters into standby mode, sound is from the last HDMI equipment selection before you turned off the receiver. If you are enjoying other equipment, play the equipment and perform the One-Touch Play operation, or turn on the receiver to select the HDMI equipment you want to enjoy. • Make sure "Pass Through" is set to "ON" in the HDMI Settings menu if you connect equipment not compatible with the "BRAVIA" Sync to the receiver (page 67). Tuner The FM reception is poor. • Use a 75-ohm coaxial cable (not supplied) to connect the receiver to an outdoor FM antennas (aerial) as shown below. Outdoor FM antenna (aerial) Receiver 78GB