Sony TC-WE605S Operating Instructions - Page 8

Advanced Playback Operations Locating a Track (Multi-AMS/ Auto Play/Memory Play) You can locate the following/previous tracks within a range of 30 tracks (Multi-AMS: Automatic Music Sensor) or the beginning of a tape quickly (Auto Play). You can even locate a specific point anywhere on a tape (Memory Play). RESET MEMORY RESET POWER DIRECTION MODE A a RELAY ØON øOFF PITCH CONTROL - + RESET MEMORY A COUNTER B RESET MEMORY g RMS/START RMS SET CHECK - RMS + DISPLAY 0(AMS) (AMS)) AUTO CAL(STARTP) DECK A DECK B 0(AMS) DUBBING A B A+B REC HIGH/NORMAL START(DECK BP) (AMS)) p CLEAR ª BACK PAUSE REC MUTE REC PRr · p FRONT DOLBY NR OFF ON ON FILTER B C S ª· PAUSE REC MUTE REC PRr § § AUTO 4 3 REC LEVEL 5 6 7 2 8 1 0 9 10 FADER ARL π SYNCHRO PHONES 0/) ª/· 0/) Note Check the direction indicator of the deck you use. When you locate a track on the reverse side (when ª lights up), press the button(s) in the parentheses. Notes • The Multi-AMS function may not work correctly if: - the blank space between tracks is less than 4 seconds long. - there is a passage of low frequencies or very low volume within a track. - the signal strength of the left and right channels are very different. • The Multi-AMS function is inoperative on a deck whenever the other deck is playing, recording (except during dubbing), or in pause. • Even if DIRECTION MODE is set to a, the deck stops when the current side reaches the end during Multi-AMS operation. • The tape counters are reset to "0.00" (TC-WA8ESA/ WA7ESA/WE805S/WE705S only) or to "0000" (TCWE605S/WR550Z/WE505 only) when you turn off the tape deck. To locate The beginning of the next or succeeding tracks (Multi-AMS) Press ) (or 0) as many times as you want during playback. For example, to locate 2 tracks ahead, press twice. The beginning of the current track (Multi-AMS) 0 (or )) once during playback The beginning of the preceding tracks (Multi-AMS) 0 (or )) as many times as you want during playback. For example, to locate 2 tracks behind, press three times. The beginning of a tape (Auto Play) MEMORY on the deck being used repeatedly until "M" disappears in the display . Then press 0 (or )) while holding down · (or ª). A particular point on a tape (Memory Play) MEMORY on the deck being used repeatedly until "M" appears in the display. Find the point you want, then press RESET to reset the tape counter and to memorize the point. To locate the memorized point and start playback, press 0 (or )) while holding down · (or ª). (Press 0 or ) to stop at "0.00" (TC-WA8ESA/WA7ESA/WE805S/ WE705S only) or at "0000" (TCWE605S/WR550Z/WE505 only). ) 8 3-810-716-11(1)