Stihl MS 193 C-E Product Instruction Manual - Page 44
Rewind Starter
View all Stihl MS 193 C-E manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 44 highlights
English Checking the Spark Plug Rewind Starter A N Clean dirty spark plug. N Check electrode gap (A) and readjust if necessary - see "Specifications." N Use only resistor type spark plugs of the approved range. Rectify problems that have caused fouling of spark plug: - too much oil in fuel mix, - dirty air filter, - unfavorable running conditions, e.g. operating at part load. 000BA039 KN 000BA071 KN 1 2 WARNING To reduce the risk of fire and burn injury, use only spark plugs authorized by STIHL. Always press spark plug boot (1) snugly onto spark plug terminal (2) of the proper size. (Note: If terminal has detachable SAE adapter nut, it must be securely attached.) A loose connection between spark plug boot and ignition wire connector in the boot may create arcing that could ignite combustible fumes and cause a fire. Installing the Spark Plug To help prolong the wear life of the starter rope, observe the following points: N Pull the starter rope only in the direction specified. N Do not pull the rope over the edge of the guide bushing. N Do not pull out the rope more than specified. N Do not allow the starter grip to snap back, guide it back into the housing slowly - see chapter on "Starting / Stopping the Engine." Have a damaged starter rope replaced by your dealer before it breaks completely. STIHL recommends that you have servicing and repair work carried out exclusively by an authorized STIHL servicing dealer. N Screw the spark plug into the cylinder. N Connect the spark plug boot (press it down firmly). 42 MS 193 C