Sub-Zero BI-36S Built-In Installation Guide - Page 38

Dual Installation 38 C Dual Installation-Flush Inset Panels When installing two built-in models side by side in a flush inset application, you must decrease the width of the decorative flush inset panels by 1/2" (13). Adjustments to the panel offsets will also need to be made. These adjustments are needed to achieve a proper fit and to ensure the panels do not collide when closing. Panel dimensions in the chart below have been adjusted to reflect the decrease in panel dimensions. IMPORTANT NOTE: If a filler strip is not used, dual installations can only be accomplished using two units with opposite hinges. Illustrations A-F provide panel offsets and reveals for all built-in models in a flush inset application. Refer to the chart below for reference to the illustrations relating to your specific model. All reveals are 1/2" (13) unless otherwise specified. For additional information on model specific panel reveals, visit the specification library section of our website, subzerotrade.com. Panel Offsets ALL REFRIGERATOR / ALL FREEZER Doors (hinge) / Grille Sides Doors (handle) Sides Grille Top Grille Bottom / Door Top Door Bottom OVER-AND-UNDER Doors (hinge) / Drawer / Grille Sides Doors (handle) Sides Grille Top Grille Bottom / Door Top Door Bottom / Drawer Top Drawer Bottom Illus. A B C D F A B C D E F Do not exceed the flush inset decorative panel dimensions. Exceeding dimensions could cause damage to the panels and the Sub-Zero unit. 5 TOP VIEW DOOR / DRAWER / GRILLE BACKER SPACER CABINETRY DOOR TOP VIEW DUAL TRIM DOOR FLUSH INSET PANEL 5/16" (8) 1/2" (13) 5/8" (16) 5/16" (8) 1/8" (3) 1/4" (6) REVEAL Illus. A Illus. B CABINETRY 1/2" (13) GRILLE 1/8" 5/16" (3) (8) SIDE VIEW GRILLE 5/16" (8) 5/32" (4) DOOR 1/2" (13) 3/32" 5/16" (2) (8) SIDE VIEW S Illus. C Illus. D DOOR DRAWER Illus. E S 5/16" (8) 3/32" (2) 5/8" (16) 5/32" 5/16" (4) (8) SIDE VIEW DOOR / DRAWER 5/16" (8) SIDE VIEW 3/32" (2) SIDE VIEW Illus. F S 5