TASCAM DA-6400 DA-6400dp Owners Manual Addendum V2.20 - Page 31

DA-6400/DA-6400dp 4. During timecode synchronized playback, press the 8 button to stop playback. At this time, the indicator on the Home Screen will blink. 5. When stopped, press the 7 or 9 [CHASE] button to start timecode synchronized playback. 6. Do one of the following to turn synchronized operation off. oo Press the 9 [CHASE] button while pressing and holding the SHIFT button on the front of the unit. oo Set the TC SYNC page TC CHASE MODE item to OFF. At this time, the indicator on the Home Screen reverts to the indicator. VAMPING mode added to repeat playback function modes VAMPING has been added to the repeat playback function modes. On the PLAY SETUP menu page, the following three options have been added for the REPEAT MODE item. Option OFF (default value) Repeat icon Meaning Repeat playback is not used. NORMAL Normal repeat playback is used. VAMPING This is the new repeat playback function mode added with this update. When this mode is active, is added to the repeat icon on the Home Screen. During repeat playback, after the 7 button is pressed the repeat icon will blink until playback of the next take starts. When playback of the next take starts, the will stop blinking. NOTE ii If the 7 Button is pressed during playback of the final 5 sec- onds of the current take, the following message is displayed, and that take will be repeated from its start to end one more time before proceeding to play the next take. In this case, the will start blinking after returning to the beginning of the take. Operation in VAMPING REPEAT MODE When set to this mode, the current take will be played back repeatedly regardless of the PLAY MODE screen setting. During repeat playback, press the 7 button* to automatically move to the next take and repeat playback after playing the current take to its end. * In addition to the front panel button, parallel, serial, or network control can be used to start playback. ii While waiting to move to the next take (when is blinking), operations including stopping, pausing, searching/backward, skipping and jumping to marks will cancel moving to the next take, and the current take will continue to repeat playback. In this case, the will stop blinking. Function added to set the input and output signal routing for each individual channel Input signal routing can now be set per channel. Output signal routing can also now be set per channel. The INPUT ROUTING 1 and INPUT ROUTING 2 menu pages have been replaced by a ROUTING page for these functions. Setting input signal routing Follow these steps to set input signal routing. 1. Open the ROUTING page and select the INPUT ROUTING item. Then, press the MULTI JOG dial to open the INPUT ROUTING settings list. INPUT ROUTING settings list TASCAM DA-6400/DA-6400dp 31