TEAC CD-RW890 CD-RW890 Manual - Page 4

Contents Before Using the Unit Thank you for choosing TEAC. Read this manual carefully to get the best performance from this unit. Before Using the Unit 4 Connections 5 Discs 6 Remote Control Unit 7 Unit Functions and Remote Control 8 Playback Basic Operation 10 Basics of Playback 10 Direct Playback 12 Shuffle Playback 12 Time Display 13 Repeat Playback 13 A-B Repeat 14 Programmed Playback 14 Recording About Recording 16 Before Recording 17 Recording 17 Synchronous Recording 20 Finalize 21 Unfinalize 21 Erasing the Last Track (CD-RW 22 Erasing All Tracks (CD-RW 23 Erasing All Tracks In Refresh Mode (CD-RW 24 Troubleshooting 25 Messages 26 Specifications 27 Read this before attempting any operations. < The nominal temperature should be between 5°C and 35°C (41°F and 95°F). The CD-RW recorder is more sensitive to extremes of temperature than ordinary CD players. < Relative humidity should be 30 to 85 percent non condensing. < As the unit may become warm during operation, always leave sufficient space around the unit for ventilation. < The voltage supplied to the unit should match the voltage as printed on the rear panel. If you are in any doubt regarding this matter, consult an electrician. < Choose the installation location of your unit carefully. Avoid placing it in direct sunlight or close to a source of heat. Also avoid locations subject to vibrations and excessive dust, heat, cold or moisture. < Do not place the unit on an amplifier/receiver. < Do not open the cabinet as this might result in damage to the circuitry or electrical shock. If a foreign object should get into the unit, contact your dealer or service company. < When removing the power plug from the wall outlet, always pull directly on the plug, never yank the cord. < To keep the laser pickup clean, do not touch it and always close the disc tray. < Do not attempt to clean the unit with chemical solvents as this might damage the finish. Use a clean, dry cloth. < Keep this manual in a safe place for future reference. < Do not tilt the main unit while a disc is inserted. Doing so may cause a malfunction. DO NOT MOVE THE UNIT DURING PLAYBACK/RECORDING During playback or recording, the disc rotates at high speed. Do NOT lift or move the unit during playback or recording. Doing so may damage the disc or the unit. WHEN MOVING THIS UNIT When changing the unit's location or packing the unit for moving, be sure to remove the disc. Moving this unit with the disc loaded may result in damage to this unit. 4