TP-Link 10GE T1700G-28TQ V1 Installation Guide - Page 7

JetStream Gigabit Stackable Smart Switch LED Status Master Link/Act On Off On Flashing Off On 1000Mbps Off 25-28 On Green Flashing On Yellow Flashing Off Indication The switch works as master in the stack system, or does not join any stack system The switch works as stack member in the stack system There is a device connected to the corresponding port but no activity Data is being transmitted or received No device is connected to the corresponding port A 1000Mbps device is connected to the corresponding port A 10/100Mbps device or no device is connected to the corresponding port A 10Gbps device is connected to the corresponding port, but no activity Data is being transmitted or received A 1000Mbps device is connected to the corresponding port, but no activity Data is being transmitted or received No device is connected to the corresponding port Unit ID LED Designed to display the stack Unit ID of the switch. For the switch that does not join any stack system, it displays its default Unit ID. To modify the default unit number, please logon to the GUI of the switch and go to Stack→Stack Management→Switch Config page and configure the New Unit ID. The new Unit ID will take effect after you reboot the switch. Reset Press this button for 5 seconds or above to reset the software setting back to factory default settings. 10/100/1000Mbps RJ45 Port Designed to connect to the device with a bandwidth of 10Mbps, 100Mbps or 1000Mbps. Each has a corresponding Link/Act LED and a 1000Mbps LED. SFP+ Port Port 25-28, designed to install the 1Gbps SFP transceiver, 10Gbps SFP+ transceiver or SFP+ cable. Port Feature Model 10/100/1000Mbps RJ45 Port SFP+ Port T1700G-28TQ 24 4 Introduction 02