TP-Link EAP115-Wall EAP115EU-Wall V1 User Guide - Page 13
WPA-Enterprise, WPA-PSK
View all TP-Link EAP115-Wall manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 13 highlights
SSID Name: Enter up to 32 characters as the SSID name. Wireless VLAN ID: Set a VLAN ID (ranges from 0 to 4094) for the wireless network. Wireless networks with the same VLAN ID are grouped to a VLAN. SSID Broadcast: Enable this function, AP will broadcast its SSID to hosts in the surrounding environment, as thus hosts can find the wireless network identified by this SSID. If SSID Broadcast is not enabled, hosts must enter the AP's SSID manually to connect to this AP. Security Mode: Select the security mode of the wireless network. For the security of wireless network, you are suggested to encrypt your wireless network. This device provides three security modes: WPA-Enterprise, WPA-PSK (WPA Pre-Shared Key) and WEP (Wired Equivalent Privacy). WPA-PSK is recommended. Settings vary in different security modes as the details are in the following introduction. Select None and the hosts can access the wireless network without password. Portal: Portal provides authentication service for the clients who want to access the wireless local area network. For more information, refer to 5.2 Portal. After Portal is enabled, the configurations in 5.2 Portal will be applied. SSID Isolation: After enabling SSID Isolation, the devices connected in the same SSID cannot communicate with each other. Modify: Click Click to open the page to edit the parameters of SSID. to delete the SSID. Following is the detailed introduction of security mode: WEP, WPA-Enterprise and WPA-PSK. WEP WEP (Wired Equivalent Privacy), based on the IEEE 802.11 standard, is less safe than WPA-Enterprise or WPA-PSK. NOTE: WEP is not supported in 802.11n mode. If WEP is applied in 802.11n mode, the clients may not be able to access the wireless network. If WEP is applied in 11b/g/n mode, the device may work at a low transmission rate. 10