TP-Link EAP115-Wall EAP115EU-Wall V1 User Guide - Page 55

Set Source

Get TP-Link EAP115-Wall PDF manuals and user guides View all TP-Link EAP115-Wall manuals
Add to My Manuals
Save this manual to your list of manuals

Page 55 highlights

Set Source: Defines the IP address (for example, 10.10.10.1) or subnet for management systems that can serve as Set Community to read and write the SNMP information of this device. The format of subnet is "IP address/bit" (such as 10.10.10.0/24). The default is 0.0.0.0, which means all hosts can read and write the SNMP information of this device. NOTE: Defining community can allow management systems in the same community to communicate with the SNMP Agent. The community name can be seen as the shared password of the network hosts group. Thus, for the security, we suggest modifying the default community name before enabling the SNMP Agent service. If the field of community is blank, the SNMP Agent will not respond to any community name. 52

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
  • 49
  • 50
  • 51
  • 52
  • 53
  • 54
  • 55
  • 56
  • 57
  • 58
  • 59
  • 60
  • 61
  • 62
  • 63
  • 64
  • 65
  • 66
  • 67
  • 68
  • 69
  • 70
  • 71
52
Set Source:
Defines the IP address (for example, 10.10.10.1) or subnet for
management systems that can serve as Set Community to read and
write the SNMP information of this device. The format of subnet is “IP
address/bit” (such as 10.10.10.0/24). The default is 0.0.0.0, which
means all hosts can read and write the SNMP information of this
device.
NOTE:
Defining community can allow management systems in the same community to
communicate with the SNMP Agent. The community name can be seen as the shared
password of the network hosts group. Thus, for the security, we suggest modifying the
default community name before enabling the SNMP Agent service. If the field of
community is blank, the SNMP Agent will not respond to any community name.