TP-Link TL-SG2424P TL-SG2424P V1 IG 7106504146 - Page 6
Reset, 100/1000Mbps RJ45 Port, SFP Port
View all TP-Link TL-SG2424P manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 6 highlights
Gigabit Smart Switch The front panel of TL-SG2424 is shown as the following figure. Reset LEDs 10/100/1000Mbps RJ45 Port SFP Port FFFFFFFFFFF Front Panel of TL-SG2424 Reset Press this button for five seconds or above to reset the software setting back to factory default settings. LEDs LED Status Indication On The Switch is powered on Power Off The Switch is powered off or power supply is abnormal On The Switch is working abnormally System Flashing The Switch is working normally Off The Switch is working abnormally Link/Act On There is a device linked to the corresponding port but no activity Flashing The corresponding port is transmitting or receiving data Off There is no device linked to the corresponding port On A 1000Mbps device is connected to the corresponding port 1000Mbps Off A 10/100Mbps device or no device is connected to the corresponding port 10/100/1000Mbps RJ45 Port Designed to connect to the device with a bandwidth of 10Mbps, 100Mbps or 1000Mbps. Each has a corresponding Link/Act LED and a 1000Mbps LED. SFP Port Designed to install the SFP module. TL-SG2216/TL-SG2424 Switch features 2/4 SFP transceiver slots that are shared with the associated RJ45 ports. The associated two ports are referred as a "Combo" port, which means they cannot be used simultaneously, otherwise only SFP port works. 02 Introduction