TP-Link TL-SG2424P TL-SG2424P V1 IG 7106504146 - Page 9
Rear Panel - tl sg2424 24
View all TP-Link TL-SG2424P manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 9 highlights
Gigabit Smart Switch LED Status Green 10/100/ 1000Mbps Yellow Off Indication On A 1000Mbps device is connected to the corresponding port, but no activity Flashing Data is being transmitted or received On A 10/100Mbps device is connected to the corresponding port, but no activity Flashing Data is being transmitted or received No device is connected to the corresponding port 10/100/1000Mbps RJ45 Port Designed to connect to the device with a bandwidth of 10Mbps, 100Mbps or 1000Mbps. Each has a corresponding 1000Mbps LED. SFP Port Designed to install the SFP module. TL-SG2452 features 4 individual SFP ports. Reset Press this button for five seconds or above to reset the software setting back to factory default settings. Port Feature Model TL-SG2216 TL-SG2424 TL-SG2424P TL-SG2452 10/100/1000Mbps RJ45 Port 16 24 24 48 SFP Port 2 4 4 4 Note: For TL-SG2216/TL-SG2424/TL-SG2424P, when using the SFP port with a 100M module or a gigabit module, you need to log on to the GUI (Graphical User Interface) of the Switch and configure its corresponding Speed and Duplex mode on Switching→Port→Port Config page. For 100M module, please select 100MFD while select 1000MFD for gigabit module. By default, the Speed and Duplex mode of SFP port is 1000MFD. TL-SG2452 supports 1000M SFP module connection only. Rear Panel The rear panel of TL-SG2216 is shown as the following figure. Grounding Terminal Power Socket FFFFFFFFFFF Rear Panel of TL-SG2216 Introduction 05