TP-Link TL-SG2424P TL-SG2424P V1 IG 7106504146 - Page 7

Gigabit Smart Switch The front panel of TL-SG2424P is shown as the following figure. LEDs LED Mode Switch Button Reset 10/100/1000Mbps RJ45 Port SFP Port FFFFFFFFFFF Front Panel of TL-SG2424P LEDs TL-SG2424P has an LED mode switch button which is for switching the LED status indication. When the Speed LED is on, the port LED is indicating the data transmission rate. When the PoE LED is on, the port LED is indicating the power supply status. By default the Speed LED is on. Pressing the mode switch button, the Speed LED will turn off and the PoE LED will light up. Then the PoE LED will turn off after being on for 60 seconds and the Speed LED will light up again. When the Speed LED is on, the port LED is indicating the data transmission rate. LED Power System Status On Off Flashing Flashing On/Off Green 10/100/ 1000Mbps Yellow Off On Flashing On Flashing Indication The Switch is powered on The Switch is powered off or power supply is abnormal Power supply is abnormal The Switch works properly The Switch works improperly A 1000Mbps device is connected to the corresponding port, but no activity Data is being transmitted or received A 10/100Mbps device is connected to the corresponding port, but no activity Data is being transmitted or received No device is connected to the corresponding port When the PoE LED is on, the port LED is indicating the power supply status. LED Power System Status On Off Flashing Flashing On/Off Indication The Switch is powered on The Switch is powered off or power supply is abnormal Power supply is abnormal The Switch works properly The Switch works improperly Introduction 03