Thermador HMIB42WS Installation instructions - Page 7

Advance Planning Before You Begin CAUTION Before installing, turn power OFF at the service panel. Lock service panel to prevent power from being turned ON accidentally. Parts Included Hood assembly (LED lamps already installed) Blower housing NOTE: Carefully remove the protective ilm from the duct cover and hood assembly prior to the start of the installation. Use one hand to maintain the assembly/duct cover steady while the other hand removes the protective ilm. Top and lower duct covers Structure horizontal supports Structure upper/lower vertical supports Grease ilters Fastener assortment* * Hardware provided is for mounting through standard thickness drywall or plaster into wood studs. Installers are responsible to provide hardware for other types of mounting situations. Tools and Parts Needed • Ducting as needed (refer to Equivalent Duct Lengths for Commonly Used Transitions Table) • Aluminum tape (DO NOT use duct tape) • 1/2'' (13 mm) Conduit if required (follow local codes) • 1'' (25.4 mm) Strain relief • Ducting as needed • Blower • Flat head and Phillips screwdrivers • Drill with 3⁄16'' (4.76 mm) drill bit • Circular saw or jigsaw • 3/8'' (9.52 mm) nut driver or socket and ratchet • Wire stripper • Protective work gloves IMPORTANT: DO NOT throw away any packaging until appliance is fully installed. Optional accessories available for separate purchase. Refer to www.thermador.com for more details. • CHXTHMIB - Telescopic Duct Cover Extension Kit • RECHMIB - Recirculating Kit • CHFHMCD - Charcoal Filter Replacement Kit • REMCPW - Built-In Remote Control Accessory Installation Instructions English | 7 |