URC DMS-AV Owners Manual - Page 40

DMS-AV HOME THEATER AMPLIFIER Automated Speaker Setup All of the manual room correction described in the previous section can be accomplished through an automated process, within the on-screen display, or the URC Accelerator Application. Included with each DMS-AV is a setup microphone, which when connected to the DMS-AV Setup Mic input, can be used to perform an automated room correction routine. The internal DSP of the DMS-AV shall execute a series of test tones to each speaker in the installation, which will then automatically determine each speaker level, correct speaker distance setting and crossover frequency. These settings will be automatically saved within the DMS-AV firmware, and URC Accelerator, if applicable. The Set up Microphone included should be the only microphone used in the automatic setup configuration. Input Settings Each of the 12 inputs on the DMS-AV supports parameters that allow for customization for each input and their function. Input Rename Each input may be renamed to better de scribe its function. The maximum amount of characters that can be used to rename an input is eight. The input name can be set in the DMS-AV on-screen display, or within the URC Acceler ator Application. Digital Audio Assign (Available for all inputs except Phono) - Each input may have their audio input reassigned to any of the two optical digital or coaxial digital (S/PDIF) inputs. The two optical digital inputs are named IN A and IN B, and the two coaxial digital inputs are named IN C and IN D. Digital audio assign options may also be used to reassign HDMI audio, in the case that a DVI input is used, requiring the use of a separate audio input. Page 41