Vantec UGT-ST310R User Guide - Page 10

Auto configuration recommended, Manual configuration

Get Vantec UGT-ST310R - SATA II 150 PCI Host Card PDF manuals and user guides View all Vantec UGT-ST310R manuals
Add to My Manuals
Save this manual to your list of manuals

Page 10 highlights

use existing hard drive(s) with data. To create a RAID 0+1 set four hard drives are required. Auto configuration (recommended) The default chunk size is 64k when selecting Auto configuration. 1. As the BIOS boots press Ctrl+S or F4 when prompted to enter the RAID BIOS. 2. At the next screen select Create RAID Set, then press Enter. 3. Select RAID10, then press Enter. 4. Select Auto configuration, then press Enter. 5. Input the RAID size, press Enter. 6. When asked Are You Sure(Y/N)?, press Y to accept. 7. Press Ctrl+E to exit the BIOS. 8. When asked Are you sure to exit(Y/N)?, press Y to exit and reboot. 9. Continue with FDISK and FORMAT steps as if you were installing a conventional hard drive. Manual configuration 1. As the BIOS boots press Ctrl+S or F4 when prompted to enter the RAID BIOS. 2. At the next screen select Create RAID Set, then press Enter. 3. Select RAID10, then press Enter. 4. Select the number of drives then press Enter. 5. Select Manual configuration then press Enter. UGT-ST310R Page 10

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
UGT-ST310R
Page 10
use existing hard drive(s) with data. To create a RAID 0+1 set
four hard drives are required.
Auto configuration (recommended)
The
default
chunk
size
is
64k
when
selecting
Auto
configuration
.
1.
As the BIOS boots press
Ctrl+S
or
F4
when prompted to
enter the RAID BIOS.
2.
At the next screen select
Create RAID Set
, then press
Enter
.
3.
Select
RAID10
, then press
Enter
.
4.
Select
Auto configuration
, then press
Enter
.
5.
Input the RAID size, press
Enter
.
6.
When asked
Are You Sure(Y/N)?
, press
Y
to accept.
7.
Press
Ctrl+E
to exit the BIOS.
8.
When asked
Are you sure to exit(Y/N)?
, press
Y
to exit
and reboot.
9.
Continue with FDISK and FORMAT steps as if you were
installing a conventional hard drive.
Manual configuration
1.
As the BIOS boots press
Ctrl+S
or
F4
when prompted to
enter the RAID BIOS.
2.
At the next screen select
Create RAID Set
, then press
Enter
.
3.
Select
RAID10
, then press
Enter
.
4.
Select the number of drives then press
Enter
.
5.
Select
Manual configuration
then press
Enter
.