Vantec UGT-ST310R User Guide - Page 15

BIOS Configuration, Driver Installation, For Windows® 2000

Page 15 highlights

BIOS Configuration The 6-Port SATA II 150 PCI Host Card w/RAID BIOS will appear every time your system starts up. If the BIOS doesn't show, please try your controller in another PCI slot. During this (POST) process, the BIOS will show up and indicate the devices attached to it. Driver Installation For Windows® 2000 For A New Installation A new installation requires a floppy disk for the driver installation. To make this floppy disk, copy the contents of the "UGT-ST310R\2000_XP_2003_Vista\32bit" folder, found on the driver CD, onto a blank floppy disk then follow the directions below. 1. Setup the RAID Array prior to Windows installation. 2. Follow Windows® 2000 installation procedure. 3. At the Windows® 2000 Setup screen, press F6 to install the RAID driver. 4. When prompted, press S to specify the location of the driver. 5. Insert the floppy disk, then press Enter. 6. Select Silicon Image SiI 3114 SoftRAID 5 Controller for Windows 2000, then press Enter. 7. Press Enter again to finish driver installation, then follow the on-screen instructions to complete the Windows installation. For An Existing Installation 1. Setup the RAID Array prior to driver installation and boot up UGT-ST310R Page 15

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20

UGT-ST310R
Page 15
F
BIOS Configuration
The 6-Port SATA II 150 PCI Host Card w/RAID BIOS will appear
every time your system starts up. If the BIOS doesn’t show,
please try your controller in another PCI slot. During this (POST)
process, the BIOS will show up and indicate the devices
attached to it.
Driver Installation
For Windows® 2000
or A New Installation
A new installation requires a floppy disk for the driver
installation. To make this floppy disk, copy the contents
of the
UGT-ST310R\2000_XP_2003_Vista\32bit
” folder,
found on the driver CD, onto a blank floppy disk then
follow the directions below.
1.
Setup the RAID Array prior to Windows installation.
2.
Follow Windows® 2000 installation procedure.
3.
At the Windows® 2000 Setup screen, press
F6
to install the
RAID driver.
4.
When prompted, press
S
to specify the location of the
driver.
5.
Insert the floppy disk, then press
Enter
.
6.
Select
Silicon Image SiI 3114 SoftRAID 5 Controller for
Windows 2000
, then press
Enter
.
7.
Press
Enter
again to finish driver installation, then follow the
on-screen instructions to complete the Windows installation.
For An Existing Installation
1.
Setup the RAID Array prior to driver installation and boot up