Vantec UGT-ST310R User Guide - Page 16

to Windows. 2. At Found New Hardware Wizard, click Next. 3. Select Search for a suitable driver for my device (recommend) then click Next. 4. Insert the driver CD, check CD-ROM drives, uncheck the other boxes, click Next, then click Next again. 5. If the Digital Signature Not Found message appears, click Yes. Our driver has been thoroughly tested for stability and compatibility. 6. Click Finish. 7. Repeat steps 2-6. 8. Restart Windows to complete the driver installation. For Windows® XP/Server 2003 For A New Installation A new installation requires a floppy disk for the driver installation. To make this floppy disk, copy the contents of the "UGT-ST310R\2000_XP_2003_Vista\32bit" folder, found on the driver CD, onto a blank floppy disk then follow the directions below. 1. Setup the RAID Array prior to Windows installation. 2. Follow Microsoft's Windows installation procedure. 3. At the Windows Setup screen, press F6 to install the RAID driver. 4. When prompted, press S to specify the location of the driver. 5. Insert the floppy disk, then press Enter. 6. Select Silicon Image SiI 3114 SoftRAID 5 Controller for Windows XP/Server 2003, then press Enter. 7. Press Enter to finish driver installation, then follow the on- screen instructions to complete the Windows installation. UGT-ST310R Page 16